Views: 10 Author: Site Editor Publish Time: 2018-07-01 Origin: Site
There are three ways to take the PVC pipe coupling down.
1. use a saw blade, and then use a section of a large diameter tube (used as a casing), the inner hole at both ends of the brush PVC glue, and the original pipe bonding, after curing, it can be used normally.
2. if the metal pipe joint is screwed down directly, if it rusts, add a few drops of lubricating oil.
3., apply PVC glue to the inner wall and ignite for 10 seconds. After the fire is extinguishing, the inner wall is quickly prized out with a screwdriver, and the fittings can be used two times.
PVC is polyvinyl chloride (PVC) and PVC (Polyvinyl chloride), which is a initiator of perchloroethylene monomer (vinyl chloride monomer, referred to as VCM) in peroxides, azo compounds, or polymers under the action of free radical polymerization under the action of light and heat. Vinyl chloride homopolymer and vinyl chloride copolymer are collectively referred to as vinyl chloride resin. Its material is a non crystalline material. PVC materials are often added stabilizers, lubricants, auxiliary processing agents, pigments, impact resistant agents and other additives. It has no flammability, high strength, weather resistance and excellent geometric stability. PVC has strong resistance to oxidants, reducing agents and strong acids. However, it can be corroded by concentrated oxidizing acid such as concentrated sulfuric acid and concentrated nitric acid, and it is not suitable for the contact with aromatic hydrocarbon and chlorinated hydrocarbon.
The conditions of the PVC tube should be implemented under the following conditions:
Drying treatment: dry treatment is usually not required.
Melting temperature: 185~205C.
Mold temperature: 20~50C.
Injection pressure: it can be as high as 1500bar holding pressure: it can be as large as 1000bar injection rate: to avoid material degradation, the injection rate is usually considerable.
Runner and gate: all conventional gates can be used. For smaller parts, it is better to use pin type gate or submerged gate; for thicker parts, fan gate is preferred. The minimum diameter of needle gate or submerged gate should be 1mm, and the thickness of fan-shaped gate should not be less than 1mm.
Typical uses: water supply pipes, household pipes, wall panels, commercial machine shells, electronic products packaging, medical devices, food packaging, etc.
If you are intrested in PVC pipe coupling, just contcat us for more details.